![]() I'll try to make some pics today about my (permanent) setup based on a ELM327. Īs per accessing the various Nodes, you'd need to connect to either one of the two CAN buses: this is done thru a wiring adapter (mainly Yellow or #3 on FIATs), doesn't matter which kind of interface you use ! Other FTDI chip based readers might use direct driver, so MES wouldn't recognize them. It allows you to perform various diagnostics tasks on the supported vehicles/modules. ![]() ![]() FIAT Multiecuscan v4.8 is a vehicle diagnostic software with advanced functions. Once received on the device, the informations are processed by the software (in case of direct driver like FDxxx) OR converted to a virtual COM port and a serial-like signal.Īs I understand, MES can only cope with serial input, being virtual or strictly physical doesn't matter: it just have to listen to the correct port with the correct parameters !Īs far as I know, ELM327 based EOBD wi-fi interfaces (OBD reader) don't use direct driver so they should be able to communicate with MES. This is Multiecuscan 4.8 Crack Version ,REGISTERED with cheap Price Software only ,No interface included.
0 Comments
Leave a Reply. |